The one layer rectangles and not perfect, in some places the lines separate, but they are mostly fine. I did another round of bed leveling and Z alignment to make sure the adhesion is good and a test print came out quite fine in all corners and the center. There were other quality problems too with this print, and you can already see that in the walls there are holes: Then I tried to switch to bigger items, but the printing failed half-way due to not enough adhesion. When I got after bed leveling I got a decent result from the demo dog and started to print small things, where the quality was acceptable. Trying to print with 1.75 mm PLA, but the results are very bad, unfortunately.
I'm new to 3D printing, I bought an Ender 5 Pro just recently.
0 kommentar(er)
